Secondary State Definition
” that appears after each “Secondary State Name” corresponds to
the static secondary state definition. For example, the “Inhibit
In Progress” secondary state is defined by
InhibitInProgress
, which corresponds to the static definition InhibitInProgress.
IltSettings.SetValue()
must include the secondary state definition and the primary
state. For example:
Secondary
State Name
Secondary State Definition
|
When
Applicable: OOS, NT, CT |
Comment
|
||
---|---|---|---|---|
Blocked
Blocked
|
No
outgoing traffic is allowed on the entity. The restriction is
imposed by the far-end network element. |
|||
Busy
Busy
|
The
entity is currently in use and has no spare operating
capacity for further usage demand. |
|||
Cold
Standby
ColdStandby
|
The
entity is about to back up another entity and is synchronized
with the backed-up entity. It requires initialization before
it can take over. |
|||
Combined
Combined
|
This
load-sharing entity has assumed the load of its mate entity
in addition to its own. |
|||
Diagnostic
Diagnostic
|
Diagnostic
activity that affects the service is currently being
performed on the entity. |
|||
Disconnected
Disconnected
|
Subscribed
service has been disconnected, but still exists in the
database with a specific intercept treatment. |
|||
Exercise
Exercise
|
|
|
|
Service-affecting
exercise is currently being performed on the entity. |
Facility
Failure
FacilityFailure
|
The
associated transport facility is OOS. |
|||
Far
End Processor Outage
FarEndProcessorOutage
|
The
processor at an associated far-end network element is OOS. |
|||
Fault
Fault
|
The
entity is OOS because it is faulty. |
|||
Forced
Forced
|
|
|
The
entity has been manually forced into the In Service state
from an Out Of Service state that occurred under the normal
procedure. |
|
Hot
Standby
HotStandby
|
The
entity is to back up another entity and is synchronized with
the backed-up entity. It does not require initialization
before it can take over. |
|||
Idle
Idle
|
The
entity is available to provide service, but is not currently
used. |
|||
Idle
Receive
IdleReceive
|
|
Applicable
to bidirectional termination points only. The receiving
direction is not cross-connected. |
||
Idle
Transmit
IdleTransmit
|
|
Applicable
to bidirectional termination points only. The transmission
direction is not cross-connected. |
||
Inhibit
In Progress
InhibitInProgress
|
The
entity is waiting for users to terminate before transitioning
to OOS. |
|||
Locked
Out
LockedOut
|
No
outgoing traffic is allowed on the entity. This restriction
may be imposed for maintenance reasons. |
|||
Loopback
Test
LoopbackTest
|
A
loopback activity is being performed on the entity. |
|||
Maintenance
Maintenance
|
The
entity has been manually removed from service for maintenance
activity. |
|||
Maintenance
Limited
MaintenanceLimited
|
|
|
|
Normal
trouble detection function is not provided for the entity
because of defects developed in the entity or in an
associated entity. |
Mismatch
Of Equipment
MismatchOfEquipment
|
The
entity is installed with improper equipment or circuit pack,
or the correct equipment has improper attributes. |
|||
Monitor
Monitor
|
The
entity has reached a monitored performance level considered
as abnormal. |
|||
Overflow
Overflow
|
The
entity has no more storage capacity for capturing additional
information. In this state, the entity is read-only. |
|||
Performance
Monitor Inhibited
PerformanceMonitorInhibited
|
The
performance monitoring function of the entity has been
temporarily suspended. |
|||
Power
Power
|
The
entity is abnormal or OOS because there is a defect in the
power supply. |
|||
Pre-Post
Service
PrePostService
|
The
entity has been manually removed from service for the
pre/post-service administration activity. |
|||
Protection
Release Inhibited
ProtectionReleaseInhibited
|
The
entity is inhibited from protection release. |
|||
Protection
Switch Exercise
ProtectionSwitchExercise
|
A
protection switching exercise is currently running on the
entity. |
|||
Protection
Switch Inhibited
ProtectionSwitchInhibited
|
The
regular protected entity is inhibited from switching to
protection. |
|||
Protocol
Protocol
|
The
entity is OOS due to a Layer-2 or higher protocol violation.
|
|||
Providing
Service
ProvidingService
|
The
redundant (backup, protecting) entity is currently providing
service. This value is mutually exclusive of cold-standby,
warm-standby, and hot-standby. It is equivalent to the
Working secondary state. |
|||
Rearrangement
Rearrangement
|
The
entity has been removed from service because of physical
and/or logical rearrangement activity. |
|||
Red
Lined
RedLined
|
The
entity is a special (red-lined) circuit. |
|||
Software
Downloading
SoftwareDownloading
|
Software
download activity is currently being performed on the entity.
|
|||
Software
Transfer Inhibited
SoftwareTransferInhibited
|
Software
transfer is inhibited on the entity. |
|||
Software
Transfer Only
SoftwareTransferOnly
|
Only
software transfer is allowed on the entity. |
|||
Software
Uploading
SoftwareUploading
|
Software
upload activity is currently being performed on the entity. |
|||
Standby
Inhibited
StandbyInhibited
|
The
standby entity is inhibited from taking over the role of the
backed-up entity. |
|||
Standby
Switched
StandbySwitched
|
Indicates
the state of a protection system, for example, switched on to
provide service. |
|||
Supported
Entity Absent
SupportedEntityAbsent
|
The
associated support entities are absent. |
|||
Supported
Entity Exists
SupportedEntityExists
|
The
entity is currently supporting other entities. |
|||
Supporting
Entity Absent
SupportingEntityAbsent
|
The
associated supporting entities are absent. |
|||
Supporting
Entity Outage
SupportingEntityOutage
|
There
is an outage on the supporting entity. |
|||
Supporting
Entity Swapped
SupportingEntitySwapped
|
The
associated supporting entity has swapped to a spare (backup)
entity. |
|||
Suspend
Both
SuspendBoth
|
Any
attempt to establish connection to or from the entity is
administratively inhibited for non-maintenance reasons. |
|||
Suspend
Origination
SuspendOrigination
|
Any
attempt to establish a connection with the entity is
administratively prohibited for non-maintenance reasons. The
consequences are the same as disabled, which is used for
maintenance. |
|||
Suspend
Termination
SuspendTermination
|
Any
attempt to establish a connection with the entity is
administratively prohibited for non-maintenance reasons. The
consequences are the same as disabled, which is used for
maintenance. |
|||
Switched
System Activity
SwitchedSystemActivity
|
The
entity is removed from service due to switching system
activities. |
|||
Terminated-Both
Terminated-Both
|
When
applied to a termination point, the receiving signal is
terminated and an insertion word is transmitted instead of
the normal signal. |
|||
Terminated-From
Terminated-From
|
When
applied to a termination point, the receiving signal is
terminated. |
|||
Terminated-To
Terminated-To
|
When
applied to a termination point, an insertion word is
transmitted instead of the normal signal. |
|||
Test
Test
|
Test
activity, other than loopback, diagnostics, and exercise, is
currently being performed on the entity. |
|||
Test
Failure
TestFailure
|
The
object is OOS due to a test failure. |
|||
Transferred
Transferred
|
The
load sharing entity has transferred its normal load
responsibility to its mate entity. |
|||
Warm
Standby
WarmStandby
|
The
entity is to back up another entity and gets synchronized
with the backed up entity at regular intervals. It does not
require initialization before it can take over. |
|||
Working
Working
|
The
redundant (backup, protecting) entity is currently providing
service. This value is mutually exclusive of cold-standby,
warm-standby, and hot-standby. |
Secondary
State Name
Secondary State Definition
|
Visual
(OOS only) |
Comment
|
---|---|---|
Pre-Post
Service
PrePostService
|
The
entity has been manually removed from service for the
pre/post-service administration activity. |
|
Unassigned
Unassigned
|
The
entity has not been assigned the required provisioning data.
No service or maintenance is permitted in this state since
the necessary data has not been assigned. |
|
Unequipped
Unequipped
|
The
equipment entity has not been equipped with the necessary
hardware or the software entity has not been loaded with the
necessary data or code. |