Rogue Wave JViews Maps for Defense
>
Developing with design tools
>
Using the Designer
>
Using more Designer features
>
Importing data from a flat file
>
Selecting the diagram type
INDEX
|
PREVIOUS
NEXT
Selecting the diagram type
You need to select a diagram type for the correct positioning of the nodes.
Because you have latitude and longitude mapped, the Map Diagram is selected by default, see the following figure.
Note
If the JViews Maps product is not installed, the X/Y Diagram is selected by default. Click Finish.
Specifying a map diagram
To select the Map diagram:
Click
Finish
.
If you need to make changes, you can click
Back
instead to return to specific wizard pages.
The resulting diagram is as shown in the following figure.
The initial Arizona physical diagram
Keep the diagram open to proceed to the next section or save it by clicking
File > Save As
.
Current section
Importing data from a flat file