Running on UNIX

Before starting PV‑WAVE, make sure to run the setup file for your system:

From a C shell:

source $RW_DIR/wave/bin/wvsetup

where RW_DIR is the directory in which PV-WAVE is installed.

From a Korn or Bourne shell:

. $RW_DIR/wave/bin/wvsetup.sh

where RW_DIR is the directory in which PV-WAVE is installed.

where RW_DIR is the directory in which PV-WAVE is installed.

To start PV‑WAVE, at the operating system (OS) prompt type the following:

wave

or to start 64-bit PV‑WAVE type the following:

wave -64

and press <Return>. The PV‑WAVE prompt appears.

WAVE>

This is a mode where you can interactively enter commands at the WAVE> prompt. If you see an error and PV‑WAVE does not start, refer to the PV-WAVE Installation Guide for troubleshooting information.

 

note	For UNIX users, if you set the WAVE64 environment variable to 1, the "-64" flag will not be necessary to start 64-bit PV-WAVE.

To run the PV-WAVE Navigator, type navigator at the WAVE> prompt.

 

Note	To start PV-WAVE in Runtime mode, type 'wave -r application', where application is the name of the compiled procedure file, without the .cpr extension.